Physical AI News (Japan)

Physical AI, robotics and compute — reported from Japan.

日本語
· Research & technology· 日本語で読む

UC San Diego Research Team Develops Soft Robot That Requires No Electronics

TechXplore reported that a UC San Diego research team developed a soft robot that uses no electronics. The six-legged robot moves at speeds of up to 4.72 meters per second, the report said. Its legs are driven pneumatically, and the robot can operate on sand and underwater, according to the report.

What happened

TechXplore reported on November 18, 2026, that a UC San Diego research team developed a six-legged soft robot that uses no electronics and moves at speeds of up to 4.72 meters per second. The robot is 3D-printed all at once from a single material and can run on sand, mulch and concrete, as well as swim and walk underwater, according to the report.

Why it matters

In the reported design, an internal mechanism that channels pressurized air moves the legs, without the use of electronics. The design could be considered as a way to avoid incorporating electronic circuits, but the conditions for the overall system, including its air supply, are important in assessing its practicality.

Analysis

The notable point in this report is not just the robot’s speed, but its use of pneumatic rather than electronic components to drive its locomotion. According to TechXplore, chambers, valves and tubes inside the robot are connected, and pressurized air drives the legs. The absence of electronics therefore does not mean that the robot requires no external energy or operating conditions. The robot’s speed on its own should be assessed separately from the practicality of the overall system, including the equipment needed to supply and regulate air. The reported top speed is 4.72 meters per second, compared with 4 centimeters per second for an earlier robot developed in 2022, which the article cites as a benchmark. A simple conversion puts the new figure at about 118 times faster, but the article text provided does not specify the measurement conditions, the distance over which the speed was sustained, or the test setup, including power and air supplies. The difference in figures therefore cannot be taken as a direct measure of performance in real-world environments or expanded applications; the conditions for comparison need to be verified. The single-material, one-step 3D-printing method can be understood as a design that integrates the robot’s structure and operating mechanism. Not relying on joints between multiple materials or the incorporation of electronic components could be relevant when considering manufacturing processes and maintenance. However, the article does not provide information on material durability, wear during repeated operation, production time or yield, so it is not possible to conclude that the method is easier to manufacture than conventional approaches. Further evaluation should examine the conditions under which the top speed was achieved, as well as speed and operating time across different terrain, required air pressure, and the weight and portability of the system, including its supply equipment. The report that the robot can walk underwater and swim does not specify water depth, duration or control method. Information on these operating conditions and durability will be needed to determine which environments the robot could serve beyond laboratory demonstrations.

Sources

Translated from the Japanese original: /news/uc-sandiego-no-kenkyuu-chiimu-denshikiki-fuyou-no-nantai-rob-b50619. The Japanese version is authoritative if they differ.