· Product launches· 日本語で読む
TDK announces communication solution for rotating parts using 60 GHz wireless
TDK announced Nov. 9, 2026, that it would begin offering a communication solution for rotating parts using 60 GHz wireless. The solution combines its IOHA:B signal aggregation technology with a rotation-compatible antenna to support continuous 360-degree rotation. The focus is whether it can provide an alternative to contact-based sensor signal transmission in robotic rotating joints.
What happened
TDK announced Nov. 9, 2026, that it would begin offering a solution to transmit data from rotating parts using 60 GHz wireless communications, ITmedia reported Nov. 12. The solution combines TDK's IOHA:B signal aggregation technology with a rotation-compatible antenna and supports continuous 360-degree rotation.
Why it matters
For designers transmitting sensor signals through robotic rotating joints, the solution offers an alternative to contact-based methods. TDK says it can help reduce failures and maintenance costs caused by contact wear, as well as the increased size and cost of slip rings as transmission data volumes grow.
Analysis
The key point of the announcement is a design that replaces contact-based components with wireless transmission for sensor signals passing through rotating mechanisms. According to ITmedia, TDK aggregates sensor signals using IOHA:B and transmits them via 60 GHz wireless and a rotation-compatible antenna. Eliminating mechanical contacts is intended to avoid wear on slip rings and brushes. However, the article does not provide figures for operating conditions such as transmission speed, latency or communication stability during rotation.
In robot joints, the path for sending information collected by sensors to the robot body is also part of the design of rotating and moving components. If the stated concerns about wear from contact-based transmission and increased component size and cost as data volumes grow are accurate, the significance of this approach lies less in wireless transmission itself than in integrating sensor signal aggregation with communications for rotating parts. However, without details on antenna placement and signal aggregation requirements, it is not possible to determine how widely the solution can be applied to existing joint designs.
A report covered by this newspaper, Memories.ai reported to build a standardization pipeline for first-person video data for robots, described a pipeline for handling video data from robots. It does not indicate that the pipeline uses the same system or serves the same applications as this communication solution. However, when considering data acquisition for robots, the transmission paths for camera video and joint and sensor signals need to be evaluated separately. Whether acquired data can be used for training depends not only on the communications method but also on data synchronization and usage conditions.
Future evaluations should examine the effective data rate during 360-degree rotation, communication stability, latency, noise resistance, power consumption, the number of supported sensors and integration requirements. ITmedia's article does not provide specific figures or test conditions using an actual device. The impact of the reductions in wear and maintenance costs cited by TDK also cannot be estimated for each application without knowing the comparison conditions and operating period.
Sources
Translated from the Japanese original: /news/tdk-60ghz-obi-musen-wo-tsukau-kaiten-bu-muke-tsuushin-soryuu-753cb7. The Japanese version is authoritative if they differ.